Outer circlip which is mounted on the brake anchor plate to fix the brake pads.
This BZ disk is suitable for the front and rear brake anchor plate of Puch Supermaxi mopeds with Grimeca wheel hub.
Details
| Nominal diameter | 6 mm |
| Fuse type | Inside |
| Manufacturer | Puch |
| Place of use | Brake anchor plate |
Suitable for the following models
| Puch |
Moped fans like you also bought:
Magura gas cable clamp / deco cable clamp Ø 5 x 6 mm
Thread type: M4x0.7 (standard thread) · Manufacturer: Magura · Material: Brass · Material: Steel · Drive: Slot · Number of components: 2 pcs · Total length: 6 mm · Surface: nickel-plated · Ø Cable bushing: 1.6 mm · Screw head: Lens head · Ø outside: 5 mm · Thread length: 4 mm
2,35 EUR
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing cage: "-" Sheet steel cage ball-guided · Inner ring width: 12 mm · Manufacturer: NTN · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Groove ring: No · Material: Plastic · Material: Steel · Stock number: 6001 · Bearing type: Deep groove ball bearing · Surface: blank · Width: 8 mm · Ø inside: 12 mm · Ø outside: 28 mm · Ball bearing closed: Yes · Area of application: Standard
6,85 EUR
Union pedals plastic standard
Thread type: FG14.3 (9/16" 20G) · Manufacturer: Union · Material: Plastic · Material: Steel · Color: black · Drive: Hexagon socket · Drive: Outer edge · Total length: 129 mm · Surface: rubberized · Width: 77 mm · Height: 29 mm · Reflectors: Yes · Width across flats SW: 15 mm
15,00 EUR
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Thread type: MF12x1 (fine pitch thread) · Manufacturer: swiing® revival parts · Material: Steel · Total length: 185 mm · Surface: galvanized (blue) · Ø shaft: 11.9 mm · Ø outside: 11.8 mm · Shank length: 100 mm · Thread length: 26 mm · Thread length: 52.5 mm · Width across flats SW: 19 mm
17,30 EUR
Not in stock
Collection only possible with online purchase and appointment.
